Download the AutoCAD drawing of the manufacturing facility.
Use this file to do the following:
- Use the DIST command to find the following information regarding Molders M21 and M22 (see Cell 3).
- DISTANCE ON CENTER ________________________
- Are these two molders aligned on the Y-Axis (See the Delta X):_______________(Y/N)
- Use the DLI (DIMLINEAR) command to answer the following:
- Is the spacing between Molder M21 and M22 the same as it the distance between M22 and M23? _______________(Y/N)
- Use the DAL (DIMALIGNED) to answer the following:
- What is the shortest distance from M21 to M27 (3 bays to the left)
- Distance: _________________
- Draw a line from the center of M21 to the exact center of the Video-Jet Room
- Use the LIST command to see how long this line is. Length: ____________inches
- If a pipe runs from the center of M27 to the exact center of the Video Jet room, and another pipe runs from center of S-12 to L-12, what acute angle is formed? ________________°(use the DIMANG command).
- What is the XY location of the center of M23? X:__________, Y:_________ (use the ID command).
DESIGN PROBLEM
Design a plate that will fit between SILO #1 and SILO #2 with .5″ of clearance off each silo. The plate should be 36 inches wide. Assume the tank dimensions and spacing have been verified and are accurate.
