These assignments are to accompany the course Tool Design
Tool Design Lab Safety
ALL INFORMATION PRESENTED HERE IS PROVIDED "AS IS," AND THE AUTHORS MAKES NO REPRESENTATIONS OR WARRANTIES, EXPRESS OR IMPLIED, OF ANY KIND WITH RESPECT TO THIS SITE OR ITS CONTENTS. THE AUTHORS DISCLAIM ALL REPRESENTATIONS AND WARRANTIES, INCLUDING, WITHOUT LIMITATION, WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, TITLE, COMPLETENESS AND NON-INFRINGEMENT
Machining Review

Review the working drawing below. Develop a strategy to machine the workpiece described. Each nonconforming dimension will count 5 points. NOTE: you will only be given one piece of stock. You cannot start over if a dimension is out of tolerance. Machining ReviewDownload
Tool Design Spreadsheet

You will create an Excel workbook to do the following calculations: 1) Total Unit Cost 2) Break Even Point 3) Economic Lot Size 4) Punching Force For both round and rectangular punches Use inches, lbs, PSI Force to perforate (From TECH 3421: Punching Force) Lecture on Punching Stress in punch (From TECH 3401) Minimum Requirements Must be...
Engraver Project

Project SlidesReview/Preview: Limits & Fits For reference, the fit limits will be base on a .501 diameter hole. RC3 - Precision Running Fit (engraver in holder) RC9 - Loose Running Fit (plug in holder) FN5 - Force Fit (plug in holder, press fit) PDF Files of Engraver Drawings Engraving-Cutter-RC3-501 PDFDownload Engraving-Cutter-AssemblyDownload Holder-RedactedDownload Plug-RedactedDownload Limits and...
Reamer Design

Create a model of a reamer based on the parameters in the PDF file below. Use the parameters that correspond to the last digit of your TECH 4476 Student Number. The included angle of flute is 80° for all (as shown in the video). Suggested radius inside flute is .030. Feel free to change this...
Tool Design Lab Safety
ALL INFORMATION PRESENTED HERE IS PROVIDED "AS IS," AND THE AUTHORS MAKES NO REPRESENTATIONS OR WARRANTIES,...
Machining Review
Review the working drawing below. Develop a strategy to machine the workpiece described. Each nonconforming...
Tool Design Spreadsheet
You will create an Excel workbook to do the following calculations:
1) Total Unit Cost
2) Break...
Engraver Project
Project Slides Review/Preview: Limits & Fits
For reference, the fit limits will be base on...
Reamer Design
Create a model of a reamer based on the parameters in the PDF file below.
Use the parameters...